The back bumper is all reassembled and also took some time to air up the tires.

We install the drivers side marker light, which went easier then the passenger side. The driver side also lines up better too, which means we musta not lined up or welded up the passenger quarter properly.

After patching the firewall hole, we reinstall the wiper system and test the sprayers and THEY WORK !!

So most of the hard part is done now, or atleast the main parts that I wouldn't be able to do back in Winnipeg, as I don't have a garage or a welder.

... and the drivers side is looking good.

Time to install the intermediate ebrake cable and adjust the ebrakes to hold the car in gear.

New End-Link kits that were installed by Brandan & Shelly. Glenn gives me a hand setting the tune the car alittle bit better.

Glenn and I set up the timing and adjusting the carb & idle. Seems the ol' monojet is gonna need a rebuild. After that's done, Glenn & I attempt to reattached the rear bumper.

Rear Bumper is attached. Now to center and tighten down.

Page 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 / 13 / 14 / 15 / 16 / 17 / 18 / 19 / 20 / 21

Back to Pictures 2006 Menu